TPU 95A
Arrival Lime
- Nozzle
- 220–235 °C
- Bed
- 40–60 °C
- Chamber
- Not required
- Speed
- 15–35 mm/s
- Cooling
- 50 %
- Drying
- 60 °C / 6 h
- Batch
- issued per lot at dispatch
ZV-TPU-95-ALI · scan / learn / make
ZV-TPU-95-ALI
TPU · TPU 95A
TPU 95AArrival Lime
High-visibility flexible for bumpers and wear indicators.
On request
for pricing and minimum order
750 g · Matte
Diameter
1,75 mm
Other colours in TPU 95A
Print settings
- Nozzle
- 220–235 °C
- Bed
- 40–60 °C
- Chamber
- Not required
- Speed
- 15–35 mm/s
- Cooling
- 50 %
- Drying
- 60 °C / 6 h
- Diameter
- 1,75 mm
Print settings are the common starting window for this material class, not measurements. Calibrate with a temperature tower and a flow test on your own machine.
Properties
- Shore hardness
- 95 AISO 7619-1 · PolyFlex™ TPU95
- Density
- 1,20–1,24 g/cm³ISO 1183 · PolyFlex™ TPU95
- Elongation at break
- 551 %ISO 37 · XY · PolyFlex™ TPU95
Benchmarked on published grades: Polymaker PolyFlex™ TPU95 · Polymaker · 27/08/2026
TPU 95A
The flexible grade that behaves. Firm enough to feed through most extruders at sensible speeds, soft enough to seal a joint and take a hit.
Best for
- Gaskets and seals
- Grips, feet and bumpers
- Cable strain relief
Watch out
Retraction is the enemy. Keep it under 1 mm and print slow before you print pretty.
Direct drive preferredDry storage
Arrival Lime · #c7f36b
The properties on this page are values published in the named manufacturers' data sheets, measured on their grades to the standard printed against each row — not measurements of a ZORVA spool. Use them to compare material classes, not as an acceptance specification.
Passport
Ships with the spool. Published before you buy.
The same record on the label, on this page and in the box. Batch number included, so a bad print can be traced to a specific run.
TPU 95A
- Code
- ZV-TPU-95-ALI
- Net weight
- 750 g
- Diameter
- 1,75 mm
- Finish
- Matte
- Colour value
- #C7F36B
- Polymer
- Thermoplastic polyurethane
- Process
- FDM (filament)